The pressure measured in a well after the well has been closed in for a period of time, often after 24 or 72 hours. When a reservoir is first discovered, the static pressure equals the initial pressur [..]

Water pressure head available at a specific location when no water is being used so that no friction loss is being encountered. Static pressure is that pressure observed on the engine inlet gauge befo [..]

a pressure at a point in a medium that would exist at that point in the absence of sound waves, symbol p0, unit Pascal.

The normal force per unit area at a small hole in the wall of a duct.

The normal force per unit area at a small hole in the wall of a duct.

the normal force per unit area at a small hole in the wall of a duct.

A measure of barometric pressure as if the sensor were not moving with respect to the air; Compare: total pressure; Symbols: p sub s; Typical Units: psi,lbf/in-squared; Dimensions: Mass /Time-squared * Length

The pressure in a water system when the water is not flowing. 

When water is not moving, the vertical distance (in feet or meters) from a specific point to the water surface is the static head. The static pressure in psi (or kPa) is the static head in feet times [..]

The difference in air pressure between the suction side and pressure side of the blower. Unit of measure is inches of water column (in. wc) or Pascals (Pa).

Static Pressure is the potential pressure exerted in all directions by a fluid. For a fluid in motion, it is measured in the direction normal to the direction of flow. It has the potential to either b [..]

Pressure against walls of tube, pipe or duct.

A measure of barometric pressure as if the sensor were not moving with respect to the air; Compare: total pressure; Symbols: p sub s; Typical Units: psi,lbf/in-squared; Dimensions: Mass /Time-squared [..]

The potential pressure exerted in all directions by a fluid at rest. For a fluid in motion it is measured in a direction normal to the direction of flow. Usually expressed in inches water gauge when dealing with air.

The normal force per unit area at a small hole in the wall of a duct.

A pressure measurement taken from a flowing stream that is unaffected by the stream’s velocity.

Static pressure, usually expressed in inches water column (iwc), is the pressure exerted on a surface at rest with respect to the air moving in duct. 

Condition that exists when an equal amount of air is supplied to and exhausted from a space. At static pressure, equilibrium has been reached.

Pressure against walls of tube, pipe or duct

The EPA presents the formula for static pressure as “the total pressure minus velocity pressure” in regards to airflow. According to the formula, static pressure is the pressure that pushes or presses [..]

Static pressure is the outward pressure of a substance against its container. In this industry we are concerned most often with the static pressure of the air in the duct system. Good static pressure allows for even distribution throughout the home, efficient removal of heat from the furnace’s heat exchanger or refrigerant coil, and less noise as t [..]